LitePlacer.com forums

Thanks, now works fine.

Hi, I'm trying to place tall components, like some electrolytic capacitors but, when the nozzle touch the cap and the its lower limit switch is activated, the tinyG stops until a reset is performed. This occurs only if the capacitor is in a tape, but works fine as loose component. There are no probl...

Thanks,
Now it works correctly

Hi I don't understand how to set up the axis A (motor 4) on the tab "Basic setup". For the axis A there are: Acceleration, Speed (degres/min), Travel per rev. (mm)... What is the meaning of "Travel per rev"? That axis is for rotate the nozzle, there isn' t a lineal movement. Wich...

It works. Thanks!

Hi,
Is there a way to power on the motors permanently after checking the check box "Motor Power" while the machine is idle?. It only remains active about 2 seconds.
Thanks