LitePlacer.com forums

The gcode command M115 is generally used for board identification. Apparently, the newest TinyG software gives different result than the previous firmware versions. This will be easy to fix, and you give enough information that I can go that. I’ll get back to you when I’m released from hospital (I ...

Finally got around to installing the new high-res cameras on my Liteplacer. But again having trouble getting the latest Liteplacer application software to connect to my TinyG. I reloaded the TinyG firmware (440.20) using the new Synthetos TinyG-Updater v0.6.1 https://github.com/synthetos/TinyG-Updat...

My TinyG has the following firmware according to the M115 Gcode: <== FIRMWARE_NAME:TinyG, FIRMWARE_URL:https%3A//github.com/synthetos/TinyG, FIRMWARE_VERSION:0.97, FIRMWARE_BUILD:440.21, HARDWARE_PLATFORM:1.00, HARDWARE_VERSION:8.00 <== tinyg [mm] ok> *** Cnc.Connect(), did not find a supported boar...

Thought I do a clean start for the new software. I re-flashed TinyG firmware: Version 0.97 Build 440.20 Started up LitePlacer and got the following: Application Start Version: 1.0.7849.18043, build date: 06/28/2021 10:01:26 Basic Setup tab begin UpdateVideoProcessing() BuildFunctionsList: No saved t...

Notes of new software installation ( Both early June 2021 and late June 2021 versions ) General Notes: 1. Suggestion. I recommend an "about Liteplacer menu." that gives the software version number and the hardware versions it supports. 2. Question . Is the HOME point set to X=0.000,Y=0.00...

I just unpacked the kit and ordered the parts by label, rewatched the Electrotek Assembly video and started down the assembly path. Every thing has gone fine up to Preparation Step 7. I got down to the line stating, “to tap a 20x20x140 corner pillar”. I have no such part in my kit and I cannot find ...