Loose parts

Post Reply
roberto_imai
Posts: 16
Joined: Fri Oct 30, 2015 8:43 pm

Loose parts

Post by roberto_imai »

Is it only possible to use one loose part at a time?
The machine has to halt and ask user to place component underneath camera?
JuKu
Site Admin
Posts: 1114
Joined: Thu Feb 14, 2013 3:06 pm
Location: Tampere, Finland
Contact:

Re: Loose parts

Post by JuKu »

With the current software, yes. The reason is that it is difficult to impossible to find parameters that reliably see one component as one piece, considering the vast variance of component appearances. The software doesn't know if it is seeing two smaller components or one component with a shadow in the middle, so it is much more reliable to assume there is only one component.
roberto_imai
Posts: 16
Joined: Fri Oct 30, 2015 8:43 pm

Re: Loose parts

Post by roberto_imai »

I would think that if you assign a +Y or +X and an pitch of each part from each other, it would just keep looking for more parts.
Just like if they were in a tape, except components would be on a loose parts tray.
Post Reply