The ideal orientation (narrow) isn't how liteplacer wants to see it. (Oriented 90 degrees from how you'd normally use it)
Is there any way to change orientation in software? As you can see, rotating 90 isn't possible because its a hex.
Can we rotate camera in software?
-
yaddatrance
- Posts: 9
- Joined: Sat Jun 17, 2017 8:22 am
Can we rotate camera in software?
I finished building the table and I'm going through calibration and setup, but I ran into a small snag with the up camera.
The ideal orientation (narrow) isn't how liteplacer wants to see it. (Oriented 90 degrees from how you'd normally use it)
Is there any way to change orientation in software? As you can see, rotating 90 isn't possible because its a hex.
The ideal orientation (narrow) isn't how liteplacer wants to see it. (Oriented 90 degrees from how you'd normally use it)
Is there any way to change orientation in software? As you can see, rotating 90 isn't possible because its a hex.
Re: Can we rotate camera in software?
With the current software, no.