LitePlacer.com forums

Hi,

issue is fixed with pull request #60

Regards
Peter

Hu Juha,

Has there been any progress with my request to clear the vacuum pump and vacuum valve status if the TinyG is reset?
I occasionally get a 'tried to move while Z not up' error (that is not the exact wording) and I have to reset the TinyG to recover.
If I forget to clear the vacuum flags, the problem is made worse - LitePlacer fails to pick up part due to no vacuum.

Thanks.
Regards,
Les Grant.

Hi, Is possible to download previous version from somewhere?

The latest version is buggy. Every time when I try to start a job, program tell me that all components has already placed!!!!!
Even if I use "place selected" option.

Old versions are here: https://www.liteplacer.com/software-rel ... -versions/.

I would also appreciate a more detailed error report, with the problem file if possible.

Hello.
I confirm my friend's words.
I also do not set up elements.
Each attempt ends immediately in the "PARK" position.

Krzysztof

Krzys wrote:Hello.
I confirm my friend's words.
I also do not set up elements.
Each attempt ends immediately in the "PARK" position.

Krzysztof

Same here!

JuKu wrote:Old versions are here: https://www.liteplacer.com/software-rel ... -versions/.



I would also appreciate a more detailed error report, with the problem file if possible.

Attached files below.

Thank you!

quick fixes, see viewtopic.php?f=10&t=6259

Thank you I also who you make the improvements so fast!

santosp wrote:Thank you I also who you make the improvements so fast!

In writing software, it is often fast to fix the issue, but finding it can be hard. When it can be reliably repeated, even finding the fault is not always that hard.