LitePlacer.com forums

Hi guys,
I've found some time and tried to run integrated stepper. I was in California last month and purchased it directly from AMT. I will try to install it on machine in a few weeks.
I just managed to test it on Arduino and record a short video. Connected it to Liteplacer TinyG step and direction pins and it works fine. When I find time will connect it to the machine and make a test run and record a new video.
https://youtu.be/LjBPES424Aw

Looks promising!

Fascinating, I'd like to think about your outcomes! The engine you connected has about twofold the torque than the provided engines. Likewise, being shut circle it doesn't slow down so you get to really utilize every last bit of it. TinyG controller (or some other stepper engine controller so far as that is concerned) doesn't have any way to advance the torque, so the present and speed should be set thus, that the engine doesn't slow down in the most pessimistic scenario circumstance. I question that this outcome to the engine working at max torque.