LitePlacer.com forums

Hi, I can confirm that this Torx T25 bit is suitable for all steps of the liteplacer assembly:

http://www.amazon.com/gp/product/B001AH7DCK
In particular, it's just long enough to reach through the wide extrusion piece on the critical step, but yet short enough that it can torque the self-tapping screws into the holes. Basically it's the one-stop solution for all your Liteplacer T25 needs. Highly recommended.

Also highly recommended is Juha's suggestion of the "optional" oil during the thread-tapping steps. It's really worth it, don't skip that step.