Clarifying software options
Posted: Sat Oct 31, 2015 6:00 pm
Hi there!
While still waiting for my Liteplacer to arrive and preparing table (which will be, by the way, 60*100 cm and not 60*90 cm, as some users say that 90 cm width is quite tight fit) I am checking what to do next.
I am a little confused about software, because (if I understand right???) there are 2 options:
- original liteplacer's software (http://www.liteplacer.com/downloads/)
- Rmod software (Knas, thereza) (https://github.com/Knaster/LitePlacer-ver2)
Is that correct? What to use? (and why?
)
Regards,
Gregor
While still waiting for my Liteplacer to arrive and preparing table (which will be, by the way, 60*100 cm and not 60*90 cm, as some users say that 90 cm width is quite tight fit) I am checking what to do next.
I am a little confused about software, because (if I understand right???) there are 2 options:
- original liteplacer's software (http://www.liteplacer.com/downloads/)
- Rmod software (Knas, thereza) (https://github.com/Knaster/LitePlacer-ver2)
Is that correct? What to use? (and why?
)Regards,
Gregor