Nice Demo PCB for Setup + Testing by OpenPNP community

[mrandt]

Hi,

Anthony Webb produced and published a nice Demo PCB on OpenPNP Github:

https://github.com/openpnp/openpnp/tree ... mo%20Board

Look for "Demo Board V2" Gerbers.

The PCB is double-sided and contains many packages / footprints commonly used (no QFN or BGA though).

Edit: There is actually a QFN32 on top layer; missed that on first glimpse

The copper layer also includes features to calibrate the camera and check for distortion (mm rulers + square of known size).

Pictures:

Screenshot 2016-01-27 12.58.54.png (45.99 KiB) Viewed 3336 times

Screenshot 2016-01-27 12.59.24.png (46.71 KiB) Viewed 3336 times

I think this might be very useful for testing, calibrating and benchmarking any PnP - including our beloved LitePlacers

Best regards
Malte

[mrandt]

I had a bunch of these made - I used Anthony's design so credits go to him

Only thing I changed was the mm-ruler on the back side. I figured that having that in copper would be more accurate than silkscreen.

openpnp_demo_board_front.png (999.59 KiB) Viewed 3223 times

openpnp_demo_board_back.png (1.66 MiB) Viewed 3223 times

I have about 6 of these boards left, let me know if you want one for shipping and expenses.

Cheers
Malte

[anthonywebb]

I have a few of these left as well, if anyone is interested. They are a bit updated with copper ruler, added .5mm ticks as well. There are some 0201's on there for good measure as well. Ruler is on both sides now, a few tweaks. Find them here: https://www.tindie.com/products/anthony ... pcb-board/

You can also find updated gerbers in the repo.