One suggestion for the next version from me: Make the corners of the plates round where possible.
I have several cuts now as the corners are very sharp. A Laser should have no problem making the round.
Round corners on the plates
Re: Round corners on the plates
You are right, wouldn't hurt (literally) to make those corners rounded.Pixopax wrote:One suggestion for the next version from me: Make the corners of the plates round where possible.
I have several cuts now as the corners are very sharp. A Laser should have no problem making the round.
On a more personal note, I highly recommend wearing thin protective gloves whenever doing mechanical work. I consider my fingers too valuable
I am particularly fond of this brand:
http://www.amazon.de/MaxiFlex-Ultimate- ... B00JB98YAE
Re: Round corners on the plates
You are right, i will do this. It probably makes the plates even a cent or two cheaper, as a rounded corner is faster to cut than a straight edge.