loose components pickup
loose components pickup
when the ic is a little bit turned the liteplacer picks it up and place it like that. Shouldn't it auto correct it to place it like it have to be ? or do you have to allign the red cross from the component with the red cross from the camera everytime ?
Re: loose components pickup
Ideally it should move part over up-cam, detect outline and pins and correct for both rotation and any off-centered pickup...
And not only for loose parts but also for ICs or other larger / difficult to place parts from tapes or trays.
This feature has been on the wish list since day 1 I think
Afaik, the "standard" LitePlacer software does not correct rotational error at all; but rmod fork has some features around that.
I only tested it with NQFP a while back and that worked.
And not only for loose parts but also for ICs or other larger / difficult to place parts from tapes or trays.
This feature has been on the wish list since day 1 I think
Afaik, the "standard" LitePlacer software does not correct rotational error at all; but rmod fork has some features around that.
I only tested it with NQFP a while back and that worked.