Panelizing and fiducials
Posted: Tue Apr 04, 2017 1:10 pm
Hi,
I'm having problems when trying to place panelized boards.
When setting up the "Run Job" page I press the "Panelize" button.
In the dialog box that comes active, I type in the number of individual boards that is in the panel.
The box saying "Use fiducials on CAD data, ignore this table" is ticked.
When I'm finished and presses "Ok" another dialog box pops up and says "Current fiducials don't spread out"
Whats is happening?
Kind regards
Michael
I'm having problems when trying to place panelized boards.
When setting up the "Run Job" page I press the "Panelize" button.
In the dialog box that comes active, I type in the number of individual boards that is in the panel.
The box saying "Use fiducials on CAD data, ignore this table" is ticked.
When I'm finished and presses "Ok" another dialog box pops up and says "Current fiducials don't spread out"
Whats is happening?
Kind regards
Michael