loose parts set-up?
Posted: Wed Jun 21, 2017 1:51 pm
Hi,
I encountered problems with my configuration of loose pieces is I pence that it is a bad calibration on my part but I'm not sure.
I would like to know if we could help me give me the steps to follow to conficure loose pieces !?
Because I try to place a piece that is a relay telecom model G6K-2F-Y DC5, the machine does well the puck-up but it has no rotation correction, it will directly position the parts on the PCB and when The Z-axis goes up and releases the TinyG switch shows an error!
Thanks
Christian
I encountered problems with my configuration of loose pieces is I pence that it is a bad calibration on my part but I'm not sure.
I would like to know if we could help me give me the steps to follow to conficure loose pieces !?
Because I try to place a piece that is a relay telecom model G6K-2F-Y DC5, the machine does well the puck-up but it has no rotation correction, it will directly position the parts on the PCB and when The Z-axis goes up and releases the TinyG switch shows an error!
Thanks
Christian