LitePlacer.com forums

Will put my remarks and questions here.

1. Should there be a rubber o ring between the nozzle adaptor and the pickup tube?

1. Not needed , the thread is sufficiently air tight.

I don't think this wiring diagram is up to date:
Maybe this one is correct?

http://www.levimosley.com/dir/wp-conten ... Wiring.jpg

> I don't think this wiring diagram is up to date:

It is the current one, but it doesn't seem to render correctly in current FireFox. Download it (https://www.liteplacer.com/Downloads/Li ... g_v1_2.pdf) and use Acrobat viewer.

> Maybe this one is correct?

I haven't seen that one, but it is not ok; the pump and valve are 24V.

I was viewing it in Edge, rendering also a problem.

Second wiring diagram source:

http://www.levimosley.com/dir/2018/03/2 ... ld-part-2/

Rendering ok with Acrobat, strange...

One remark: With the new camera the bolt for the X max limit is way to short, the camera smashes the belt before the switch is actuated.

And one question about the down looking camera, I have now 14mm of clearence below the diffuser. Is that enough?

ds23man wrote:One remark: With the new camera the bolt for the X max limit is way to short, the camera smashes the belt before the switch is actuated.

Thank you! Strange that nobody has notified me before. I'll go and fix that.

And one question about the down looking camera, I have now 14mm of clearence below the diffuser. Is that enough?

Up to you, really. Are you going to use components that are higher than that, and if you are going to do double sided placement, do you still have enough room? The software doesn't have any provision against hitting something with the diffuser. You also want to place the nozzle holder on the left side, so that the head enters it from right to left.

Are there disadvanteges if you put it higher up?