Timeout for Home XYZ
Posted: Sat Jul 11, 2015 8:08 pm
I got my LitePlace to work and the mechanic is running smooth and accurate.
I currently use the original Juha Software with the default homing acc and speed values (2000/2000 for X & Y 500/1000 for Z).
When I home the device from let's say the center of the work area the HomeXYZ works fine.
But I chose to set my park position in the upper right at MaxX/MaxY. When I Home XYZ from there I get a Timeout on Command {"gc":"G28.2 X0"} at the end of the X home and the mechanical step failed message.
I think that the 8000 timeout value is too short for that long run, or am I look at the wrong place?
Does this timeout also occur on other machines?
I currently use the original Juha Software with the default homing acc and speed values (2000/2000 for X & Y 500/1000 for Z).
When I home the device from let's say the center of the work area the HomeXYZ works fine.
But I chose to set my park position in the upper right at MaxX/MaxY. When I Home XYZ from there I get a Timeout on Command {"gc":"G28.2 X0"} at the end of the X home and the mechanical step failed message.
I think that the 8000 timeout value is too short for that long run, or am I look at the wrong place?
Does this timeout also occur on other machines?