Tape positions

Post Reply
paxiao
Posts: 19
Joined: Wed Aug 19, 2020 11:42 pm

Tape positions

Post by paxiao »

I am a bit new to using the liteplacer and it's software. After my computer crashed I've been starting from scratch. I have it doing the fiducials but I can't get it to go to a tape position and pick or place anything. I also can't find any directions online, can anyone help me?

Thank you!
KeithM
Posts: 16
Joined: Thu Apr 04, 2019 1:50 am
Location: British Columbia, Canada

Re: Tape positions

Post by KeithM »

The online documentation is on the Liteplacer website

https://liteplacer.com/using-the-machine/
JuKu
Site Admin
Posts: 1114
Joined: Thu Feb 14, 2013 3:06 pm
Location: Tampere, Finland
Contact:

Re: Tape positions

Post by JuKu »

For specific questions, you can email me, ask here or even chat on WhatsApp.
paxiao
Posts: 19
Joined: Wed Aug 19, 2020 11:42 pm

Re: Tape positions

Post by paxiao »

Thank you KeithM and JuKu,

I was able to make some progress with this information. I can now get the liteplacer to go above the tape position. However, it stops and reads: Optical positioning can't find feature.

Any advice on how to get past this?
Attachments
opticalpositioning.png
opticalpositioning.png (884.31 KiB) Viewed 4179 times
JuKu
Site Admin
Posts: 1114
Joined: Thu Feb 14, 2013 3:06 pm
Location: Tampere, Finland
Contact:

Re: Tape positions

Post by JuKu »

When you define a tape, you also set what vision algorithm that tape uses. In this case, paper tape. Then, you need to set up that algorithm (set of vision processing functions) using the vision processing setup table and finally, click "copy here" on the paper tape box to move the algorithm from the setup table to the paper tape. Full story on page https://www.liteplacer.com/downcamsetup/; read the whole page.
Post Reply