Up looking camera - adjusting focus?

[mikehibbett]

There is no mention of adjusting the focus of the up looking camera. Is that correct?
I notice in the "down" position the nozzle tip is out of focus. Just checking before I complete calibration.

Cheers

Mike.

[JuKu]

The focus should be adjusted for the nozzle down position, which is pcb thickness above the table surface. My apologies, this should be in the instructions. Thanks for notifying me, I’ll add this.

[mikehibbett]

Thanks Juka. I'll adjust that now.

Cheers,

Mike