Placing A Tray Of Parts

Post Reply
Flavor
Posts: 15
Joined: Wed Mar 30, 2016 10:26 pm

Placing A Tray Of Parts

Post by Flavor »

I guess I don't know if this is a software question, hardware question, or a feature request.

We get some of our parts in trays. We currently place them in the loose part area, but they are not actually loose. How can we make use of the trays, because, in theory, they should be just like a tape of components.

Here are a couple pictures of 2 different components that come in trays. The ruler is just for reference. If you need actual measurements (or any other info), please let me know.
IMG_9007.JPG
IMG_9007.JPG (2.39 MiB) Viewed 3354 times
IMG_9008.JPG
IMG_9008.JPG (2.56 MiB) Viewed 3354 times
Top
Flavor
Posts: 15
Joined: Wed Mar 30, 2016 10:26 pm

Re: Placing A Tray Of Parts

Post by Flavor »

We received some more parts in trays today.

The TSOP-40 flash chip that we had previously received in a tape/reel came in a tray this time. We noticed that they tray is much "tighter" than the tape. By that, I mean that there is a lot less slop for the chip to be out of alignment inside of the tray (compared to the tape).

How can we use the trays to have the LitePlacer grab these ICs?
Top
Post Reply

Return to “Ideas and Feature Requests”